| Vorige onderwerp :: Volgende onderwerp   | 
	 
	
	
		| Auteur | 
		Bericht | 
	 
	
		Dikke
 
 
  Geregistreerd op: 25-3-2017 Berichten: 16 Woonplaats: Utrecht
  | 
		
			
				 Geplaatst: Do, 7 Mei. 2020, 16:44    Onderwerp: Sas verwijderd | 
				       | 
			 
			
				
  | 
			 
			
				Goedemiddag
 
 
Ik heb net van mijn KTM smt uit 2012 het sas systeem verwijderd, met het bijbehorende contra stekkertje met de weerstand er tussen en nu krijg ik storing van mijn fi lampje.
 
 
Hij knipperd 6 keer kort en 9 keer lang.
 
 
Ik kan niet goed terug vinden welke storing dit precies is, ik neem aan dat het met het sas verwijderen te maken heeft.
 
 
Iemand een idee?
 
 
 
Groeten Paul[/b] _________________ Hipa | 
			 
		  | 
	 
	
		| Naar boven | 
		 | 
	 
	
		  | 
	 
	
		Dikke
 
 
  Geregistreerd op: 25-3-2017 Berichten: 16 Woonplaats: Utrecht
  | 
		
			
				 Geplaatst: Do, 7 Mei. 2020, 17:05    Onderwerp:  | 
				       | 
			 
			
				
  | 
			 
			
				http://forum.lc8.nl/viewtopic.php?t=6018&highlight=code
 
 
Dit gevonden, het slangetje los getrokken met het verwijderen van sas.
 
Net even gekeken het wordt een heel gepriegel om hem er weer op te drukken zo.
 
 
Groeten Paul _________________ Hipa | 
			 
		  | 
	 
	
		| Naar boven | 
		 | 
	 
	
		  | 
	 
	
		Dr_Bean Site Admin
  
  Geregistreerd op: 15-11-2004 Berichten: 6807 Woonplaats: Nijmegen
  | 
		
			
				 Geplaatst: Do, 7 Mei. 2020, 20:19    Onderwerp:  | 
				       | 
			 
			
				
  | 
			 
			
				zie gebruikershandleiding:
 
 
 
 
DTC (Code)	Blink code	Signal/Component	Description of error
 
P0335	2	Pick up	Malfunction
 
P0122	6	Throttle position sensor	Output signal too low (interruption)
 
P0123	6	Throttle position sensor	Output signal too high (short circuit)
 
P0222	7	Sensor for 2nd throttle valve	Output signal too low (interruption)
 
P0223	7	Sensor for 2nd throttle valve	Output signal too high (short circuit)
 
P0107	9	Manifold air pressure sensor, rear cylinder	Output signal too low (interruption)
 
P0108	9	Manifold air pressure sensor, rear cylinder	Output signal too high (short circuit)
 
P1687	11	Manifold air pressure sensor, front cylinder	Output signal too low (interruption)
 
P1688	11	Manifold air pressure sensor, front cylinder	Output signal too high (short circuit)
 
P0117	12	Coolant temperature sensor	Output signal too low (interruption)
 
P0118	12	Coolant temperature sensor	Output signal too high (short circuit)
 
P0112	13	Air temperature sensor	Output signal too low (interruption)
 
P0113	13	Air temperature sensor	Output signal too high (short circuit)
 
P1107	14	Ambient air pressure sensor	Output signal too low (interruption)
 
P1108	14	Ambient air pressure sensor	Output signal too high (short circuit)
 
P1631	15	Roll angle sensor	Output signal too low (interruption)
 
P1632	15	Roll angle sensor	Output signal too high (short circuit)
 
P0130	17	Lambda probe, rear cylinder	Malfunction
 
P0150	18	Lambda probe heater, front cylinder	Malfunction
 
P0560	24	Control unit voltage supply	Malfunction
 
P1590	25	Side stand switch	Output signal too low (short circuit to ground)
 
P0201	33	Injection valve, rear cylinder	Malfunction
 
P0202	34	Injection valve, front cylinder	Malfunction
 
P0351	37	Ignition coil, rear cylinder	Malfunction
 
P0352	38	Ignition coil, front cylinder	Malfunction
 
P1232	41	Fuel pump relay	Short circuit to positive
 
P1231	41	Fuel pump relay	Short circuit to ground
 
P0032	45	Lambda probe heater	Short circuit to positive
 
P0031	45	Lambda probe heater	Kurzschlu8 nach Masse
 
P0052	46	Lambda probe heater, front cylinder	Short circuit to positive
 
P0051	46	Lambda probe heater, front cylinder	Short circuit to ground
 
P0505	49	Idle speed control motor	Malfunction
 
PO413	54	Secondary air valve	Short circuit to positive
 
PO414	54	Secondary air valve	Short circuit to ground or interruption
 
P0603	65	EEPROM error	Malfunction
 
P1106	68	Manifold air pressure sensor, rear cylinder	Hose pulled off/defective, no vacuum
 
P1105	69	Manifold air pressure sensor, front cylinder	Hose pulled off/defective, no vacuum
 
P0638	72	Stepper motor for 2nd throttle valve	Malfunction _________________ Dr_Bean  | 
			 
		  | 
	 
	
		| Naar boven | 
		 | 
	 
	
		  | 
	 
	
		 | 
	 
 
  
	 
	    
	   | 
	
	  berichten van de laatste 24 uur 
	
	 
	  
Je mag geen nieuwe onderwerpen plaatsen Je mag geen reacties plaatsen Je mag je berichten niet bewerken Je mag je berichten niet verwijderen Je mag niet stemmen in polls Je mag geen attachments plaatsen in dit forum Je mag geen bestanden downloaden in die forum
  | 
   
 
  
Powered by phpBB
© 2001 - 2005 phpBB Group 
Hosted and administrated by   
 
		 |