lc8.nl Forum Index
  Picture Gallery   •   FAQ  •  Zoeken   •   Gebruikerslijst   •   Gebruikersgroepen   •  Registreer  •  Profiel  •  Log in om je privé berichten te bekijken  •  Inloggen

 Carterbak 690 rally 
Starting vacuum-ionfusion of epoxy resin. Resin line in the center, air-line around the edge. vacuum-foil (stretching) from the edges into the mold.
Starting vacuum-ionfusion of epoxy resin. Resin line in the center, air-line around the edge. vacuum-foil (stretching) from the edges into the mold.
Viewed: 4290 times.

epoxy resin bucked :-)
epoxy resin bucked :-)
Viewed: 4174 times.

Vacuum hose connected to the mold, air-bleeder inside to create vacuum around the complete mold.
several layers of carbon and kevlar inside. 
Some peel-ply to release the resin line in the center, once everything is set.
Vacuum hose connected to the mold, air-bleeder inside to create vacuum around the complete mold.
several layers of carbon and kevlar inside.
Some peel-ply to release the resin line in the center, once everything is set.
Viewed: 4186 times.

Resin front growing (too slowly...)
Resin front growing (too slowly...)
Viewed: 4216 times.

new prodcut, just released from the mold next to it.
new prodcut, just released from the mold next to it.
Viewed: 4138 times.

Outside, surface as-is, straight out of the mold.
Outside, surface as-is, straight out of the mold.
Viewed: 4149 times.

inside:carbon-kevlar mix, finished with thin layer of clear epoxy
inside:carbon-kevlar mix, finished with thin layer of clear epoxy
Last comment 05/01/12.
Viewed: 4243 times.

outside, after cutting off all the excess form the edges.
outside, after cutting off all the excess form the edges.
Viewed: 4176 times.

inside.
inside.
Viewed: 4183 times.

Powered by Gallery v1 RSS


Powered by phpBB © 2001 - 2005 phpBB Group
Hosted and administrated by schradtnet_mini.gif