Starting vacuum-ionfusion of epoxy resin. Resin line in the center, air-line around the edge. vacuum-foil (stretching) from the edges into the mold.
Viewed: 4401 times.
|
epoxy resin bucked :-)
Viewed: 4291 times.
|
Vacuum hose connected to the mold, air-bleeder inside to create vacuum around the complete mold.
several layers of carbon and kevlar inside.
Some peel-ply to release the resin line in the center, once everything is set.
Viewed: 4298 times.
|
Resin front growing (too slowly...)
Viewed: 4331 times.
|
new prodcut, just released from the mold next to it.
Viewed: 4259 times.
|
Outside, surface as-is, straight out of the mold.
Viewed: 4273 times.
|
inside:carbon-kevlar mix, finished with thin layer of clear epoxy Last comment 05/01/12.
Viewed: 4351 times.
|
outside, after cutting off all the excess form the edges.
Viewed: 4297 times.
|
inside.
Viewed: 4293 times.
|